Page 1 of 1
Body hole locations (continued)
Posted: Thu Jan 17, 2013 2:58 pm
by chrisk
First I checked the positions of Left and Right "Side Curtain Rod Socket.
I measured with a tape measure the distance from the seam of the back panel to the Left and Right center of the "Side Curtain Rod Socket".
Both sizes left and right are equal = 40 9/16 ".
Here are the sizes of the right panel:
A=2 1/4";--------H=15/16"
B=3 29/64";-----H1=2 23/64"
C=15/16";-------H2=4 27/32"
D=21 7/32";-----I=32 1/8"
E=33 21/64";----J=7/8"
F=24";------------K=14 21/64"
G=34 25/32";----L=5"
Chris
Posted: Thu Jan 17, 2013 7:10 pm
by wesk
Just to make sure we are all on the same page:
Posted: Fri Jan 18, 2013 3:07 am
by chrisk
Wes,
The measurement from the seam was only used to check the length to the heart of the "Side Curtain Rod Socket" on the left and right side panel.
I makes this difficult measurement accurtately a several times with a cloth tape with the same results.
The sizes L, K and G in the chart are also accurately measured from Carpenter's Square and I measured back for extra control to the "Side Curtain Rod Socket".
Chris
Note:
All measurements that I given are carefully measured and double checked.
