Page 1 of 1
carburetor throttle shaft
Posted: Sat Jan 26, 2013 9:24 pm
by Cacti_Ken
What would be the tap for the screw holes where the throttle valve goes? I broke off the screw. I was able to drill down the center of the screw. I haven't damaged the threads yet. I need to tap the remaining brass out.
I think it is a 3-48 but not sure.
Posted: Sun Jan 27, 2013 12:17 am
by wesk
3-48 is what is listed in the parts manual on page 68 for those two screws.
Posted: Sun Jan 27, 2013 7:51 am
by Bretto
Are you rebushing your throttle body as well? If so, I'd like to see.
Posted: Sun Jan 27, 2013 8:39 am
by Cacti_Ken
Thank you Wes,
Bretto wrote:Are you rebushing your throttle body as well? If so, I'd like to see.
I don't have plans to rebush the body. I don't feel any play in it.