Page 1 of 1
Induction hose support tube
Posted: Wed Mar 06, 2013 11:26 am
by RICKG
Does anyone here have dimension specifics on the induction hose support
tube? Or perhaps 1 they're willing to part with?
Posted: Wed Mar 06, 2013 3:09 pm
by Bretto
I sure wish I could help.
If I'd had to guess, its probably the same tubing as the top bows. 1" OD 16 guage. And I bet you know how I know that.
Posted: Wed Mar 06, 2013 3:49 pm
by Kendall
What dimensions are you needing? The tube is 1"OD and 57" long. Do you need the measurements for the bends, etc?
I am assuming that since you posted a photo of the fording kit for the M38 that is what you are needing. I have an extra support tube for the M38A1 but that would not do you any good.
Kendall
Posted: Wed Mar 06, 2013 4:13 pm
by RICKG
I was hoping to get measurements to possibly fab 1 up for an M-38.
Posted: Wed Mar 06, 2013 4:50 pm
by OKCM38CDN
Contact Brent Mullins, h had some a while back...
Tube
Posted: Wed Mar 06, 2013 5:32 pm
by G740
Midwest Military has them in stock also.
John