Page 1 of 1
Brake light switch question?
Posted: Thu Mar 21, 2013 7:28 am
by ECVJeeps
Does anyone know the reason for the notches in the brake light switch?
The one in the center has two notches on lower side of the shoulders, I was wondering if this had any significance?
Pat
Posted: Thu Mar 21, 2013 7:49 am
by Bretto
Probably just tooling marks from that particular shop when it was made.
Posted: Thu Mar 21, 2013 6:08 pm
by WESTCOMVIC
Check for right or left hand threads?
Posted: Fri Mar 22, 2013 8:52 am
by xdragoon
Hi Pat,
Andy sent me this info
LEFT HAND THREAD BOLTS AND SCREWS
Bolts and screws with left-hand thread shall be marked with symbols shown either on the
top of the head or on the point. Marking is required for bolts and screws with nominal
thread diameter 5 mm and larger.
http://www.metricmcc.com/catalog/Ch10/10-1022.pdf
Posted: Fri Mar 22, 2013 6:01 pm
by wesk
The left threaded markings does not apply to the photo's switches. They are all three right threaded.