Master cylinder heat shield

jeeptj1 · Post by **jeeptj1** » Thu Apr 11, 2013 2:18 pm

I might have been having a senior moment but was there a thread on the spec of the master cylinder heat shield that listed the dimensions and stuff. Thanks John jr

Bretto · Post by **Bretto** » Thu Apr 11, 2013 8:26 pm

If you are trying to make one, there is a guy on the 2a page that has a PDF drawing of one for the 2A but it will work for the M38. I made mine from it.

http://www.thecj2apage.com/forums/heat- ... eld#224706

http://www.thecj2apage.com/forums/heat- ... eld#174310

evanso1975 · Post by **evanso1975** » Thu Apr 11, 2013 11:53 pm

The only real difference I can see is the M38 one has slotted holes (so you don't need to completely remove the bolts to take it off):

http://g503.com/forums/viewtopic.php?f=105&t=116217

For very little extra work, you could modify the holes on that CJ2A one to be more M38-ish.

Bretto · Post by **Bretto** » Fri Apr 12, 2013 4:14 am

Yep.
I decided when I made mine to just leave them as holes instead of slotting then out. I doubt that I will ever take it off.

G740 · Post by **G740** » Sat Apr 13, 2013 4:26 am

Just in case you guys did not know it, I have new heat shields in stock for the MB/GPW, M38 and the M38A1 in their respective different configurations.
John
MWM

Master cylinder heat shield

Master cylinder heat shield

Heat Shield