Page 1 of 1
1952 PE-95 Intake & Exhaust Manifolds that same as a M38
Posted: Sat May 18, 2013 2:22 pm
by dayboy42
Is a 1952 PE-95-K (RMC Engine) Intake & Exhaust Manifolds the same as the (MC engine) in the M38?
They appear to be and I hope this is so as my original manifolds are junk!
This was on my M38 upon purchase: (Junk unfortunately):
From the RMC Engine:
Posted: Sat May 18, 2013 2:47 pm
by wesk
If the ports are the same shape and size you should not have any problems. Many PE95's came with a smaller set of manifolds.
Posted: Sat May 18, 2013 6:58 pm
by BCA
A photo from the top would probably show that the carburetor flange on the intake manifold is way too small for your M38 carb. Check the casting number on the exhaust manifold- you may find that the part number is the same as M38 - you'll part number in your ORD 9 SNL G-740. ... Brian
Manifolds
Posted: Sat May 18, 2013 8:29 pm
by G740
The exhaust will be the same as all the L head engines. The intake is unique to the PE gensets and will not interchange with any of the standard jeep engines and run properly.
John
Posted: Sat May 18, 2013 9:14 pm
by wesk
John,
You didn't go to Findlay?
