Page 1 of 1
hole locations
Posted: Tue Jul 09, 2013 12:26 pm
by circleburner12
needing the correct hole mounting location and dimensions for the rear reflector. installed a new rear panel and the needing the info. thxs
Posted: Thu Jul 11, 2013 5:21 am
by chrisk
Hi circleburner12,
See my member album "sinrisnekaf"on page 8.
There is an image Dimensions Rear Panel page 2of2, the location of the reflector is outlined in red.
Chris
Posted: Thu Jul 11, 2013 11:32 am
by circleburner12
thxs chrisk, unless im missing something, the dimensions you speak of on page 2 is for the jeep. im asking for the reflector mounting holes for the m100. thxs
hole locations
Posted: Fri Jul 12, 2013 1:48 am
by chrisk
Sorry, overlooked that it is a M100 trailer.
Chris
Posted: Fri Jul 12, 2013 10:07 am
by circleburner12
thanks anyway.
Hole Location
Posted: Fri Jul 12, 2013 11:39 am
by jeepman
Circleburner,I just when out and checked my 52 M100 rear panel.It just happens my reflectors are not reinstalled yet,Here are the dimensions I found.These are all measured to the center of the holes.The holes are 4 inches in from the side end of the rear panel,Note this is the end of the panel not the box side.The bottom hole is 2 and 15/16 inches up from the bottom edge of the panel itself not the frame rail.The top hole is 6 and 7/8 inches up from the bottom edge of the panel.Hope this helps.I would drill the bottom holes first then use your reflector to mark the top hole for a good fit.
Posted: Fri Jul 12, 2013 6:41 pm
by circleburner12
jeepman thank you. thxs