floor drain holes
-
buzzk
- Active Member
- Posts: 197
- Joined: Mon Dec 02, 2013 6:00 pm
- Location: Saint Augustine , Florida
floor drain holes
Can some body give me the location of the floor drain holes and what size My M38 didn t come w them every thing is corret unless the did a $&% of a patch job which I can t see It came w a artic hard top w four screws in the cowl where the gas heater goes The bell housing does not have any provisions for the venting system. There is a fitting on the transfer case and it does have the hole for the hanger bearing and for the bottom plug There is no provision for a screw in seal where the cable enters the bell housing for the clutch thx buzz
-
skyjeep50
- Jeep Enthusiast
- Posts: 606
- Joined: Mon Feb 19, 2007 6:00 pm
- Location: Illinois
In the "Photo Gallery" of this website you can usually find detail pics of most every part of a M38. In particular, Wes K has a photo of a M38 tub showing the front drains: http://www.willysmjeeps.com/v2/modules. ... _photo.php
The holes themselves are 1" in diameter and the front edge of the front holes are about 3 1/2" rearward of the sidewall brace. The back hole on the passenger side is just in front of the toolbox flange.
Your bell housing may be a civilian model - they fit the same but don't have the military features you mentioned.
The holes themselves are 1" in diameter and the front edge of the front holes are about 3 1/2" rearward of the sidewall brace. The back hole on the passenger side is just in front of the toolbox flange.
Your bell housing may be a civilian model - they fit the same but don't have the military features you mentioned.
1951 M38