Page 1 of 1
holes, brackets
Posted: Thu Feb 27, 2014 6:35 pm
by buzzk
need to know the fording tail pipe bracket mounting location and for the front snorkel as well thx buzzzz
Posted: Thu Feb 27, 2014 9:50 pm
by wesk
I would wait til I have the tailpipe bolted on before determining the exact position of the bracket. Every exhaust system tends to have slightly different tail pipe positioning based on the rest of the system installation. You will be busy adjusting the existing exhaust system angles so that the fording tailpipe stands up perfectly straight up and down parallel to the corner of the tub. Once you have the best position of the fording pipe then locate the bracket accordingly.
Be sure to utilize the downloads section of our web site:
http://www.willysmjeeps.com/v2/modules. ... tit&lid=44
http://www.willysmjeeps.com/v2/modules. ... tit&lid=22
fording kit
Posted: Fri Feb 28, 2014 6:16 pm
by buzzk
the holes on the body should alreadythere but for some reason they are not thx buzz
front holes
Posted: Fri Feb 28, 2014 6:18 pm
by buzzk
still need the measurement for the front holes for the intake this is my 3rd m 38 ive restored thx buzz
Posted: Fri Feb 28, 2014 9:05 pm
by wesk
Just go to my photo album and look at the photos of the front right fender.
Bookmark my photo album which has a few hundred detailed spec photos:
http://willysmjeeps.com/v2/modules.php? ... _album.php
M38 body album:
http://willysmjeeps.com/v2/modules.php? ... _album.php
