Page 1 of 1
windshield
Posted: Sat Mar 15, 2014 7:07 pm
by buzzk
I have to replace the channel on top of my windshield for the top can someone give me the measurements for the m 38 mine is missing thx buzzz
Posted: Mon Mar 17, 2014 5:32 pm
by BullRun
I think Daryl Bensinger carries these as a reproduction. Midwest Military may also carry them.
channel
Posted: Mon Mar 17, 2014 7:00 pm
by buzzk
I have the part just need to know at what height off the vent cover so I can spot weild it on thx buzz
Posted: Mon Mar 17, 2014 8:59 pm
by BullRun
Oh OK, if someone does not beat me to it I can get that as soon as the snow clears.
channel
Posted: Tue Mar 18, 2014 2:38 pm
by buzzk
Well kind of need it this week i'm in fl its the last thing I have to do before paint and glass thx buzzz
Posted: Tue Mar 18, 2014 5:32 pm
by ANGUS
ok. it measures 14 Inches from the underside of the rail to the bottom of the windshield seal.
Posted: Tue Mar 18, 2014 7:13 pm
by BullRun
We had a big melt today and I got out to the M38 before our next snow... spring needs to get here!
From the top edge of the rope channel to the top edge of the pressed rectangles on the vent panel I got 17 1/16th" using a tape measure clipped on the rope channel top edge measuring down to the vent panel. Ends of rope channel would be equal from ends of rope channel to edge of windshield frame. Of course the rope channel would be level. I have no idea what the +/- would be in regard to accuracy. These would of been made on a welding jig most likely so accuracy would be consistent. The rope channel ever so slightly over hangs the rubber windshield gasket by about 1/16" to 1/8th" estimate.
channel
Posted: Tue Mar 18, 2014 7:46 pm
by buzzk
O K thanks for the info I'll check it out thursday I have a 220 spot welder with 18 inch tongs thx for the input buzz