willysmjeeps.com

Posted: **Sat Mar 29, 2014 10:40 am**

the drain holes in the floor board are 3" 1/2" from the support to the first hole How far off the side are they thx buzz

Posted: **Sun Mar 30, 2014 7:14 pm**

My floorpan is any early repop unit, but my drain holes are 2 7/8" to the center.

Posted: **Sun Mar 30, 2014 7:25 pm**

Sorry forgot to mention I'm working on a m38 If somebody could give me the center of the drain hole from the side and off the support it would be very helpful I don't know if the a1 is the same i'm asuming that they are both the same on each side thx for the input and help buzz

Posted: **Sun Mar 30, 2014 7:37 pm**

I don't know if the a1 is the same i'm asuming that they are both the same on each side thx for the input and help buzz

Yeah, me either. No problem - sorry I couldn't help

Posted: **Mon Mar 31, 2014 5:06 pm**

somebody has to own a m38 out there so I can get a measurement for the center of the hold down screw for the drain holes in the front floor pan both sides they are not on this site least I can't find them thx buzz

Posted: **Mon Mar 31, 2014 7:43 pm**

It has been discussed before, a year ago maybe. Can't get at my tub right now to measure as it is still very winter here so can't empty the garage.

Posted: **Mon Mar 31, 2014 9:53 pm**

Buzz, Some times you must provide a wee bit of information before you can receive a wee bit of info. In this case it helps for you to illustrate what you want and the likelihood you will get a reply will be quite a bit better.

Here's an example:

Can someone provide me with the dimensions for A, B, C, D, E & F?

Posted: **Tue Apr 01, 2014 8:22 am**

Sorry I'm a master carpentar I guess I get ahead of my self I have a hard time explaning things I need the measurements for a,b,c,d or give me the center of the screw hole and give me the angle of the holes to the edge I can figure the rest are the 2 sides the same thx a bunch buzz

Posted: **Tue Apr 01, 2014 8:26 am**

I believe so. I'll check. It's easier to locate my way with a square and not trying to compute/measure angles. Those six dimensions will put you spot on.

Posted: **Tue Apr 01, 2014 10:24 am**

thanks for your time and support buzz

Posted: **Thu Apr 03, 2014 2:22 pm**

Okay using a scaling method and one of Wes pictures I have determined that the center hole for these is 1 1/2 inches in from the inside edge of the body. this is not angled with the floor but square to the center line of the vehicle. for methodology, the large holes are 1"/10 pixels, the center of the small center hole is 16 pixels from the tubs inside edge. 15 would be 1.5" if you are worried about the extra pixel a bit of math would figure it out.

Posted: **Thu Apr 03, 2014 6:10 pm**

O K thxs a bunch i'll give it a try buzz