Page 1 of 1
Removing Ross steering box
Posted: Mon May 19, 2014 9:04 am
by hooligan
I have a new (to me) rebuilt box and column. Is the easiest way to get the box out to come up through the floor as in the 8014? Or is there an easier method? Get it on a hoist and drop down? Remove the fender (assuming I can) and out the side?
Thanks for any pointers...
Warren
Posted: Mon May 19, 2014 9:29 am
by wesk
Pull the steering wheel and drop it out the bottom.
Posted: Mon May 19, 2014 12:34 pm
by hooligan
Great. Thanks Wes... I will get it on a hoist and give it a try...
Posted: Mon May 19, 2014 9:07 pm
by wesk
Or invite 5 guys over for a cold one, line them up on the left side of the jeep and have them pick the left side up waste high while you slide the steering assembly out.
Posted: Tue May 20, 2014 3:52 am
by hooligan
Posted: Tue May 20, 2014 8:08 am
by RICKG
wesk wrote:Or invite 5 guys over for a cold one, line them up on the left side of the jeep and have them pick the left side up waste high while you slide the steering assembly out.
Just so things don't get out of hand be sure to keep the beer on ice till
after the jeep lift is complete
Posted: Tue May 20, 2014 8:23 am
by Rick_L
That will buff right out.
Posted: Tue May 20, 2014 10:10 am
by whydahdvr
Must have been reaching for their cell phone like the MBTA bus driver Sunday AM that drove her bus through a guard rail over the Mass Pike. Kind of looks the same!
Posted: Sun Jun 08, 2014 9:04 am
by hooligan
Unfortunately there was no way the column and box were coming out the bottom without removing thr mc, exhaust, we'll just about everything... Out through the floor...
New (rebuilt in June 1985 for the Canadian Forces) one in and new front springs and shackles... Almost a new vehicle now... Just need rear springs, tires, windshield hinges, hood hinges, various switches, etc, etc...
