Page 1 of 1
Loom routing
Posted: Fri Sep 05, 2014 11:21 am
by Hammerun
Loom routing. Coming from the back of the jeep on the drivers side of the frame passing the master cylinder and the steering box. How is the loom routed into the engine compartment? I see existing clips on the skirt of the inner fender but getting around and between the MC and steering box and away from the steering gear and exhaust pipe. It surly doesn't just dangle there. My frame is boxed in behind the MC and steering box so there's no chance of getting behind it. How do you run the loom through there?
Posted: Fri Sep 05, 2014 3:30 pm
by 4x4M38
Posted: Fri Sep 05, 2014 3:39 pm
by 4x4M38
TM9-8015-2 has some more photos mainly in tub and engine removal.
Page 67 in particular describes wiring harness disconnect points and shows part of the harness routed around the steering box. That may be the horn portion of the harness.
Page 70 may also be of interest. It shows the harness coming from the rear going up and around the master cylinder against the fender.
Page 73 has another view.
Posted: Fri Sep 05, 2014 3:44 pm
by Hammerun
It looks like it's running on the outside of the steering column to me, of course mine is somewhere else on the inside of it. Thanks Brian.
