willysmjeeps.com

I used to have this back in the day; however due to computer hard drive crashes, I no longer have it...

Does anyone have a drawing / dimensions for the splash shield that goes under the regulator...

I believe the same shield is used on the M-38 as is used on a M-38A1...

Please drop me a line at kb1zq@swbell.net or kb1zq@hotmail.com

Thanks

They are a bit different.


M38 is flat along the outboard edge of the frame.


M38A1 has a compound set of bends at it's rt frt corner to angle up the frame. Also the panel has about 1 1/2" more sheet forward of the mount bracket compared to the M38.

Thanks Wes, I forgot the A1 shield was different...

Went and checked the box of parts that I have sandblasted and primed already and low and behold it was on the bottom of the box...

#@$%@ CRS (Can't Remember Stuff) syndrome...

I would like the drawing for the M38 version. Anyone have it? Thanks.

Dan