Page 1 of 1
Vacuum lines etc
Posted: Wed Dec 10, 2014 9:08 am
by Shakinboxcarjoe
I am finishing an M38 24 volt project which I had to put it back together without the luxury of taking it apart! Yes, a basket case. Question: motor is put together but do I need all of the vacuum lines: distributor, etc hooked up to make it run? I do not have intentions to make it submersible again, just getting it to run. Thanks!
Posted: Wed Dec 10, 2014 9:52 am
by wesk
If you are talking about a short test run then no. If you are talking about driving it around town you really should make sure the PCV system is installed correctly and the vent line to the distributor is installed correctly. The rest of the fording package is not necessary.
Posted: Wed Dec 10, 2014 3:13 pm
by Shakinboxcarjoe
Thanks again Wes. You've been a huge help through this