willysmjeeps.com

Posted: **Fri Dec 12, 2014 7:12 am**

I see the photos of this shield on Wes's album, but does anyone have a dimensional drawing of this part. Seems like it could be easily made. Thanks.

Dan

Posted: **Sat Dec 13, 2014 7:39 am**

If you need one I have an extra

Posted: **Sat Dec 13, 2014 8:26 am**

I need the dimensions for the shield and the mounts for item PO removed the whole thing and the battery tray to fit the chevy engine

Posted: **Sat Dec 13, 2014 12:24 pm**

PM sent Bill.

Dan

Posted: **Sat Dec 13, 2014 12:24 pm**

Xamon;

Wes has the dimensions and drawing for the mount in his photo album.

Dan

Posted: **Mon Dec 15, 2014 7:15 am**

This posts seems to have gotten off track. I need the dimensions for the voltage regulator guard. Anyone?

Dan

Posted: **Mon Dec 15, 2014 9:39 am**

Is the part you need dimensions for the flat plate the mounts are bolted to?

Mine is still there if that is what you need. If there is an additional plate I don;t have that one.

Brian

Posted: **Mon Dec 15, 2014 11:23 am**

Dan, Back on track

Posted: **Mon Dec 15, 2014 11:36 am**

Dan, the best I could do while measuring the plate while mounted in the vehicle:
10-1/2" x 8" with the dubbed off corner being 45 deg, 2" x 2".

Posted: **Mon Dec 15, 2014 12:33 pm**

Thanks Rick.

Dan

Posted: **Sun Feb 22, 2015 4:43 pm**

I am trying to figure out if any of these bends in this regulator mounting base are supposed to be there, or if I should try to straighten all the bends to have two flat sides...

Posted: **Sun Feb 22, 2015 5:33 pm**

Aaron,
Two flat planes. Flat on top, flat on the side next to the engine.
Everything else is Bubba mods...

willysmjeeps.com

M38 Regulator shield dimensions.

M38 Regulator shield dimensions.