Page 1 of 1
sheet metal
Posted: Fri Feb 06, 2015 9:33 am
by buzzk
Having different readings on my sheet metal gauge for the M38 Are the 38's 16 gauge or 18 gauge or a mix Buzz
Posted: Fri Feb 06, 2015 11:48 am
by 4x4M38
18 Buzz.
sheet meatl
Posted: Fri Feb 06, 2015 12:30 pm
by buzzk
thx buzzz
Posted: Fri Feb 06, 2015 5:41 pm
by DaveM38A1
If making patch panels, 18ga. cold rolled works well.
last time I checked prices, around here about $47 a 4X8 sheet.
Dave
Posted: Fri Feb 06, 2015 10:59 pm
by Bretto
If you have a sheet metal shop in your area they might sell off reminants at a good price.
Posted: Wed Feb 11, 2015 6:45 pm
by jimm
I have read on this forum in the past that the floor is 16 GA and all other is 18 GA. Makes sense but I don't know if it is correct.
Posted: Thu Feb 12, 2015 6:18 am
by Bretto
When I redid my floors, I did them and the hats in 16 the rest in 18. Haven't seen you around here for a while Jim, welcome back.
Brett
Posted: Fri Feb 13, 2015 8:10 pm
by jimm
Bretto wrote:When I redid my floors, I did them and the hats in 16 the reset is 18.
Can you back me up on documentation for the 16GA for floor thing, or am I blowing smoke?
Bretto wrote:Haven't seen you around here for a while Jim, welcome back.
Brett
Mainly because I have been making squat for progress on my project! Undented and painted a Toyota Corolla in the meantime, and restored a portable forge, and now have a garden trailer improvement and repaint project in the works, and then I have to undent and paint my wife's Subaru Forester. Willys waited sixty years, I guess he can wait a little longer . . .
Posted: Fri Feb 13, 2015 8:27 pm
by wesk
I would consider the floors as major panels and TM 9-1804B page 163 Par. 153 says all major panels are 18 gauge.
Posted: Fri Feb 13, 2015 8:36 pm
by jimm
That sounds pretty definitive! My tub is easily accessible right now, so I'll make some thickness measurements at several points and report back.
floor
Posted: Thu Feb 19, 2015 2:45 pm
by buzzk
I have a NOS floor and it gauges at 18 Buzzzz