willysmjeeps.com

my next question is on the radiator seal kit., I'm at removing the staples from the old seal kit on the radiator shroud.



What do you do the attach the new one. I'm not that far but as I'm taking the old one off it sure got thinking of how the new one will go on

steve

Steve,
That's the url for the page your photo is on. You need to use the url for the photo itself. You get that one with most browsers by right clicking on the photo you wish to use and click "Copy Image Url" then paste that url between the If you are Microsoft's IE then you must right click on the photo and click on "Properties" then copy the Url from the Properties display box and paste that Url between the

Goes on just the same as the old one came off.
I just used some .025 MIG wire as staples.

Or, if you are very careful in removal of the staples you can re-use them. If you are not into a factory resto then do what the motor pools and we do, pop rivet them back on. You use only one staple hole for the pop rivet and skip the other hole and move on to where the next staple was.