checking lights

eagle64 · Post by **eagle64** » Sat May 09, 2015 10:52 am

Finally I'm starting to re assemble my m38. I started putting one of the head light assemblies together and thought what if the lamps aren't good.

So my question is is there a way to check the lights before I put them back in again. Is there a way to do this with a 12 volt battery? I thought it might work but just not as bright.

Any ideas?
Thanks

Post by **wesk** » Sat May 09, 2015 10:58 am

Yes just not as bright. Or just use an ohm meter.