Page 1 of 1
Throttle Cable Length
Posted: Fri Jul 10, 2015 10:39 am
by rick25
Hello,
I have a NOS Locking Throttle Cable but am unsure if the length is correct (too short) and my Jeep is not together for me to check.
Does anyone know the correct OAL (from T- handle to tip of cable) for the cable or can point me to a resource?
Thanks,
Rick
1967 M38A1 CDN2
Posted: Fri Jul 10, 2015 2:24 pm
by 4x4M38
Rick,
It may be in the ORD 740.
I can measure mine later but I have a civvy carb.
I know it's pretty short.
Posted: Fri Jul 10, 2015 6:44 pm
by 4x4M38
Hi Rick,
I could not find the length in Ord 740.
My throttle cable was too long when I purchased it. I shortened it using photos of installed cables as well as fitting it to the dash and carburetor
clamp and the throttle lever assembly.
My total length for the wire is 26" from the end of the wire or core to the end of the T-handle, pushed in all the way.
Total length for the conduit is 22-1/2" from the end of the conduit to the end of the T-handle pushed in all the way.
Again, I am using a civvy carburetor. Wes and others may weigh in and tell us if the measurements for the factory military carb are different.
Unless yours are substantially shorter than mine, I'd wait until reassembly to determine if what you have will work. If it is too long you can cut it to length.
Take care,
Brian
Posted: Tue Jul 14, 2015 9:57 am
by Boze
I suggest you cut it to length after you install it. The clamp that holds the choke cable sleeve also holds the throttle cable sleeve and the cable itself should get another half inch more from where the stop screw on the linkage holds the cable in place. Measuring could be hazardous because there is lots of opportunity for error.
Just my opinion.