Page 2 of 2
Posted: Fri Aug 16, 2019 5:16 pm
by 4x4M38
http://www.willysmjeeps.com/v2/modules. ... op+bow+rod
Short bow goes to the front. Center of common bolt hole at bottom to horizontal rod hole at top.
Posted: Fri Aug 16, 2019 9:00 pm
by kenperkins
my bows are in the down position on the jeep. hooking a tape on the end of the short bow, it measures 25 1/2 to a 3/8 hole. I have a NOS short bow for a spare and when I lay it down and measure to the 3/8 hole it's 25 3/4h.
I think I would put the top on and lay the rod in the sleeve it lives in and check the measurement that way...be sure the top is warm and tight.
Posted: Sun Aug 18, 2019 8:10 am
by 4x4M38
That’s good advice. Your measurements are within reason.
I was measuring from the center of each hole.
Posted: Thu Nov 14, 2019 5:12 pm
by wesk
Those 5 photos I started this post with have vanished along with the online photo storage site I had them on back in 2008.
Any chance anyone here downloaded my 5 photos and still have them and remember where they are? Perhaps you could post them again here?
Posted: Mon Dec 02, 2024 9:54 am
by EM2024
Does anybody have the drawing 1 to 5 for the top bow publish on Jan 27 , 2008 , the measure are there but they need to be refer to the drawing.
I try to build my own top bow and i need to double check the measure before i finish to build the die to punch the bracket
thanks