mutt wheels
Posted: Sat Jul 14, 2007 10:56 pm
will mutt wheels fit on a m38a1/m170? just looking for cheap rollers to use during restoration
Page 1 of 1
Posted: Sat Jul 14, 2007 11:07 pm
Center hole is too small. You can cut it out but that will weaken the wheel. Some early (1960 thru about 1979) Ford F150 4WD pickup wheels will fit.
Posted: Mon Jul 16, 2007 1:20 pm
Before prevouis owner dismantled my jeep, the one i restored i think there were mutt wheels at the back....
possible they fit at the rear axle not at the front axle ?
Erik
possible they fit at the rear axle not at the front axle ?
Erik
Posted: Mon Jul 16, 2007 1:42 pm
The center hole of the 151 wheel is too small for the front hubs. The wheel offset also causes interference issues with the fenders.