Page 1 of 1
Engine Plates
Posted: Thu Aug 14, 2008 11:07 am
by ocwd
I posted this on G503 because I do not know how to post pictures here. Help is appreciated.
http://www.g503.com/forums/viewtopic.ph ... 168#718168
Posted: Thu Aug 14, 2008 7:42 pm
by Ryan_Miller
Hey,
I could be wrong, but that braket looks like a buba add on.
Both would be correct (minus that add on bracket), and have the flywheel timing hole for the early engine/ starter/ flywheel, the one on the right appears to bethe best one. I can't say for the bell housing since they are covered up.
Wes might know.
Engine plates
Posted: Thu Aug 14, 2008 8:53 pm
by ocwd
Ryan,
I had two of those engine plates with that bracket attached. I think it's a factory bracket. I'll probably go with the green one but i'd sure like to know what the other one goes to and what the extra bracket is for. I sold the other one for $30 at Papago. I have a feeling that it's for the MB/GPW.
Dave
Posted: Thu Aug 14, 2008 9:24 pm
by Ryan_Miller
Dave,
You are probably right. I don't know the particulars on GPW/MB plates.
Wes will know.
Posted: Sat Aug 16, 2008 11:42 am
by wesk
Yep, that's Mb and bracket is for the engine stay cable.