What is it.
Posted: Tue Feb 09, 2010 7:17 pm
What is this. I have the box but what are the wires going to ? 
Page 1 of 1
Posted: Tue Feb 09, 2010 7:23 pm
Can you post the other two views?
Identity
Posted: Wed Feb 10, 2010 6:16 am
That is the floor plate for the arctic heater. It goes in place of the floor plate that unbolts from the passenger toe board.
John
John
Posted: Wed Feb 10, 2010 6:38 pm
John wins! the wire went to the control box from the engine heater.
Posted: Fri Feb 12, 2010 11:24 pm
That's kinda what I thought. Does anyone have a photo(I'm sure Wes does)of what the heater and switch looks like ? Oh Wes, I didn't have the other views cause this was on E-Bay. Got it for $5.00. Even though I already have one but didn't have the wires. Since my M38 has a Arctic cab I might as well have a heater too. Thanks for the replys Fellas.
Posted: Sat Feb 13, 2010 12:18 am
It's not for the gas fired personnel heater kit though. It is for the power plant heater kit and is covered in TB 9-2855-3.
Item G is you plate.
Item BB in this photo is your plate.
Item G is you plate.
Item BB in this photo is your plate.
Posted: Sat Feb 13, 2010 12:38 am
I knew it !!! Wes, you got all the answers. Thanks alot. That explains the
heater core in the bottom fo my cowl batt. box. By the way, you must stay up all night looking at all the posts on these forums.(WMJ,Yahoo,SS and the G503) It's 10:30 PM on the West Coast.
heater core in the bottom fo my cowl batt. box. By the way, you must stay up all night looking at all the posts on these forums.(WMJ,Yahoo,SS and the G503) It's 10:30 PM on the West Coast.
Posted: Sat Feb 13, 2010 8:15 pm
They're not that hard to keep up with.
You have a rare M38 since we find very few with the power plant kit still installed. If at all possible can you email me some detailed photos of the parts of the kit you still have installed?
wsknettl@centurytel.net
You have a rare M38 since we find very few with the power plant kit still installed. If at all possible can you email me some detailed photos of the parts of the kit you still have installed?
wsknettl@centurytel.net
Posted: Sun Feb 14, 2010 5:18 pm
Not much installed. When I got the Jeep it was all tore apart. Didn't have an engine. Dude Bubba'd a 289 ford in it. He went and skrewed up the frame by cuttin off the round cross member and weldin a plate accross the frame. Motor mounts were junk also. I'm just tryin to put her back together. I'll send you what I can. I don't even have any data plates.