Page 1 of 1
Spare mount hole size
Posted: Tue Oct 25, 2011 4:57 pm
by Bretto
What is the drill size of the 4 holes on the tub where the spare tire mount would go if this was a civy 3A tub? Mine are a bit egged out but one looks to be 5/8". From pictures I've seen, its correct to have them there right?
Thanks,
Brett
Posted: Tue Oct 25, 2011 6:03 pm
by rgmutchler
Brett,
Two of my holes look pretty good still and they measure out to 5/8 in the tub. The hole in the bracket in the fender well seems to be 9/16.
I can send pictures if you want.
Posted: Tue Oct 25, 2011 8:39 pm
by donthedickens
If you are talking about mounting on the passenger side, the bolts that hold the spare tire carrier to the side of a civilian jeep are 3/8 inch fine thread. There also is a brace inside the fender well to add strength to the assembly.
You can see some info on the CJ3B Page;
http://www.film.queensu.ca/CJ3B/Tech/Spare.html
Posted: Tue Oct 25, 2011 9:12 pm
by Bretto
Thanks guys. I just needed the hole size. I am going to use the existing 2 holes I have to orient the others. I have have made a pattern from the spare mount. I'm not going to use it, just doing body work (never ending).
Brett