M38 floor panel
Posted: Mon Dec 26, 2011 6:40 am
On both sides of the floor panel over the transmission are small bullet shaped indents, anybody know what they were used for????
Page 1 of 1
Posted: Mon Dec 26, 2011 7:49 am
Drainage, on my floor they are like little vents going down, allowinf water to drain out...
Posted: Mon Dec 26, 2011 11:14 am
The little indents are a left over from the WWII MB tub floor stamping and were there for the positioning of the exhaust pipe clamp.
Posted: Mon Dec 26, 2011 9:14 pm
Wes,
I think he's talking about the small indentions on either side of the transmission cover part of the floor pan. Not the ones you have pictured. I don't have a picture handy to use to illustrate.
I think he's talking about the small indentions on either side of the transmission cover part of the floor pan. Not the ones you have pictured. I don't have a picture handy to use to illustrate.