Page 1 of 1
Fuel, vent & vacuum lines
Posted: Wed Apr 19, 2006 7:23 pm
by Cacti_Ken
What are the outside diameters of the fuel, vent, and vacuum lines? I'm hooking up the fuel pump to carburetor first then I'll go from there. also I am making them. Does anyone have a list of what connectors are needed?
I can get some idea from the manual, but not for all.
Posted: Wed Apr 19, 2006 8:10 pm
by BobW
I have a database of vent system parts located here...
http://www.cj3a.info/sibling/m38vent/vent4.htm
It should have every part of the vent system which includes some vacuum parts. The lines are called tubes or lines in the parts manuals. The diameter and length should be listed for each line.
The complete vent system article is here...
http://www.cj3a.info/sibling/m38vent/vent.htm
Posted: Thu Apr 20, 2006 9:09 pm
by Cacti_Ken
Wow!! Bob, you put a lot of work into that list.
thanks.
Ken
Posted: Fri Apr 21, 2006 4:16 pm
by OKCM38CDN
Seeing if I can post to this topic...
Have tried several times and no go...
Posted: Fri Apr 21, 2006 11:21 pm
by wesk
Hal,
You have to log on first.
Posted: Sat Apr 22, 2006 6:49 am
by OKCM38CDN
Will not take anything but a one line entry... and the welcome at the top says I am logged in. this is the only post I cannot post to...
Posted: Sat Apr 22, 2006 7:34 pm
by wesk
OKCM38CDN wrote:Will not take anything but a one line entry... and the welcome at the top says I am logged in. this is the only post I cannot post to...
That's a two line entyry right there. Your messages are clearly posting.