Page 1 of 1
Throw out bearing carrier
Posted: Fri Sep 20, 2013 8:57 am
by bl5211a
Hello: i noticed the replacement throwout release bearing carrier has its spring eye location about 1" forward of original.
Is this an issue?
Will it cause spring to fail due to over stretching?
My original carrier has some wear from fork.
Brian 1955 m170
Posted: Sat Mar 16, 2024 8:01 am
by CapnDan
Posted: Sat Mar 16, 2024 8:03 am
by CapnDan
FYI, my photo album is on page 23 of the members albums, if you want to a larger image.
Posted: Sat Mar 16, 2024 8:05 am
by 4x4M38
Hi Danny,
I never got a response.
Posted: Sat Mar 16, 2024 1:01 pm
by wesk
I'd stick with original clutch sleeve and spring. If you elect to use a different sleeve then make sure you have the vendor advise you of what model it is for and if he has the correct spring for that model.
As for knowing what is correct simply look at the illustration in the M38A1 TM 9-8014 page 232 figure 122.