willysmjeeps.com

Posted: **Sun May 11, 2014 11:53 pm**

please can someone tell me the diemensions from the m38 front driver seat and specific what is showing on the photo

Also the front cushion what is the height of the bottom one as is showing on the photo

Why I m asking is because i have put new set of cushions in my m38 and the drivers seat is now a little height and that makes me to look not in the center of the windshield but much more upper!!!!! I want to know if the problem is from the cushion or from the seat because when i was restoring my m38 my friend told me that he will use the passenger seat and will modify it!!!

Posted: **Tue May 13, 2014 7:45 am**

My original drivers seat frame is about 10 3/4" from the floor to the underside of the frame just in back of the front leg. I have the original steel coil spring cushions - they are about 4 1/2" tall from the lower edge to the top of cushion in the middle of the seat.

Posted: **Tue May 13, 2014 2:03 pm**

thanks

Posted: **Wed May 14, 2014 8:36 am**

Something to keep in mind is that back in the 40s and 50s people were on average shorter than they are today by several inches.

Posted: **Wed May 14, 2014 10:27 am**

Xamon wrote:Something to keep in mind is that back in the 40s and 50s people were on average shorter than they are today by several inches.

i m not tall ....i m 1.70cm

Posted: **Wed May 14, 2014 10:44 am**

wow you are short I am 6'3" about 190cm if my math is right

so yeah you should fit well in these vehicles, heck you could drive an m3 stuart don't think I can even fit in the drivers seat of one.

now looking at the historic photo gallery I find the shots of guys driving the M38 they are looking out the top of the window like this one

willysmjeeps.com

m38 front driever seat and front buttom cushion diemensions?

m38 front driever seat and front buttom cushion diemensions?